Line_AlignSlope(id,position);

Post by **Tormentor667** » Thu Apr 06, 2006 0:37

This would make textures on a wall with "id" slope with the plane of the sloped sector itself (position defines if ceiling or floor is used as reference)

Post by **Graf Zahl** » Thu Apr 06, 2006 0:52

I have no idea what you want here.

Shinjanji · Post by **Shinjanji** » Thu Apr 06, 2006 5:50

Textures that are sheared and manipulated so that they follow the slope of a floor or ceiling. For example, if you had a ramp, and a wall with horizontal stripes, the stripes on the wall could be sheared to follow the slope of the ramp. I'm all for the idea.

Post by **Enjay** » Thu Apr 06, 2006 9:06

I think this was once asked about over at Zdoom.org. People seemed to like the idea, generally, but I don't think there has been anything done about implementing the feature. Some of timmie's earlier ZdoomGL versions had this in some circumstances, but, in that case, it was a bug not a feature.

Post by **Graf Zahl** » Thu Apr 06, 2006 9:21

You know, I'd really like to add some texture scaling features. However, this would only make sense if it worked in the software renderer as well but unfortunately I don't understand that code well enough to change it so it'd be up to Randy - and I think we all know what would come out of that...

Post by **Tormentor667** » Thu Apr 06, 2006 12:59

Not scale, slope

Here is an example:

The wall texture at the side of the sloped sectors gets vertically aligned to the floor or ceiling, whatever you choose as reference!